Free gardening gloves when you spend $75.00 or more!
Survival Pack Installation
Survival Pack is the best assurance that newly planted trees will live and thrive. But Survival Pack does much more than just increase survivability. It also enables trees to grow faster and stronger.
Survival Pack includes:
TREE PRO tree protector -- proven by users to be the best in the industry;
NUTRIPAK controlled release fertilizer -- places nutrients in the root zone where they're needed most;
DIEHARD transplant mix -- beneficial mycorrhizal organisms and biostimulants to make sure roots are strong and healthy;
WEED PRO weed mat with staples -- the safest way to kill weeds.
INSTRUCTIONS FOR INSTALLATION:
DIEHARD Transplant Mix
Empty packet of the Diehard Transplant Mix into the soil to be used when planting the transplant. Mix well. Plant transplant using the soil. The mycorrhizal blend will help the root system to absorb the nutrients and moisture in the soil.
NUTRI-PAK Controlled-Release Fertilizer
Nutri Pak controlled-release fertilizer is designed to release a controlled amount of NPK into the soil around the tree's roots over time.
Please read instructions on the package itself for complete directions. NutriPak is designed to be placed inside the hole as it is. Do not tear open and empty the package contents into the hole. Tiny pores in the package allow the contents to slowly dissolve and seep into the tree's root zone at a controlled rate over a period of several years.
WEED PRO Weed Mats
Weed Pro can be used with or without a protector and you can install it before installing the protector or after. (It's better to install Weed Pro before installing the protector so that it covers the ground inside the protector next to the tree.)
Carefully slide the top of the tree and/or protector through the "X" cut in the center of the weed mat, and then lower the mat to the ground. Fold the corners over to double the thickness of the mat for the staples to go through.
Pound the staples into the ground, at an angle away from the tree, being careful not to bend them. Weed Pro is properly installed when it is taut and flat to the ground.
PROTECTORS & SHELTERS
After planting the tree in accordance with proper tree planting directions, pound or press the stake into the ground at a distance from the tree equal to about one-half the diameter of the protector.
The stake should be on the side of the tree toward the prevailing wind; e.g., if the prevailing wind is from the west, the stake should be on the west side of the tree.
The top of the stake should be several inches higher than the top lock-tie that secures the protector to the stake.
- Fold the collar back over the outside of the protector, with the smooth side of the protector on the inside. The purpose of the collar is to provide a soft rim so the trees' bark won't be damaged.
PLEASE NOTE: Many tree planters have found it advantageous not to fold the collar. They've found that if the collar is left upright, birds will not light on it because it's too flimsy to support their weight. Also, it saves time because it's one less step. Even with the collar up there should be no abrasion of the tree's trunk.
- With the holes lined up, slide the lock-ties through both holes in each sidewall and lock the tie two or three clicks to keep it from falling out.
- Carefully slide the protector down over the top of the tree and the lock-ties down over the stake.
PLEASE NOTE: If the trees have branches, carefully gather them together with their tips facing up before lowering the protector.
- Make sure the bottom of the protector is in good contact with the ground.
PLEASE NOTE: Proper protector installation does not require the protector to be pressed down into the ground because doing so can sometimes cause rodent problems. Mice, voles and other animals often build nests inside protectors that are too firmly planted in the ground.
- Tighten ties.
Miracle Tube
1. Miracle Tubes come nested with lock-ties already in place. Their diameters range from about 3 1/4 to about 4 1/2 inches. Choose the smaller diameter tubes for smaller trees and the larger diameter tubes for larger trees.
2. Carefully slide the protector down over the top of the tree and the lock-ties down over the stake.
PLEASE NOTE: If the trees have branches, carefully gather them together with their tips facing up before lowering the protector.
3. Make sure the bottom of the protector is in good contact with the ground.
*Numbers of Lock-ties are for Tree Pro only. Miracle Tube comes with lock-ties already inserted in the appropriate holes.